Hi, New to this forum and finding new firmware for my Iomega NAS: Iomega StorCenter Device Iomega StorCenter ix2-200 2.1.42.18967.

Storage Manager is the software used to setup the device as well as to access a Personal Cloud. Iomega storcenter ix2 200 nas 6tb 2 x 3tb 2 bay cloud.

Contents • • • • • • Download imager firmware For the EZ Media, download. For the ix2-ng, download Create imager stick Extract the file to a FAT formatted USB stick, of at least 1GB. Prepare disk Ensure both disks are initialized with GPT partition table. Use the utility gdisk or fdisk to do this. Now extract the files zImage and initrd from emctools/xxx_images/xxx.tgz.

Connect the disk to your (Linux) PC, and write the files to the raw disk: dd if=/path/to/zImage of=/dev/sdb seek=2048 dd if=/path/to/initrd of=/dev/sdb seek=8192 Of course doublecheck that sdb is your intended nas disk. Dd will happily overwrite whatever you offer as target. Install firmware Put the disk in the nas, plugin the stick, power it up, and after about 10 minutes (depending on your USB stick), the box should power-off. Remove the stick, and power it on again. After a few minutes you can connect to the webinterface. If there is an indication in the web page that the box is still starting, leave it alone until it's done. It is initializing the data volume.

If you interrupt it, there will be No shares When there are no shares available, do a factory reset (System->Factory Reset). After rebooting, connect to webinterface. If there is an indication in the web page that the box is still starting, leave it alone until it's done. Hozyajstvo latinskoj ameriki prezentaciya 11 klass live. It is initializing the data volume.