FT2232SPI Programmer. From flashrom. Film impact transition pack 1 full. The following setup can then be used to flash a BIOS chip through SPI. Pin (JTAG Name) SPI/Voltage Source: 1 (VREF) VCC (from Voltage Source) 2 (VTARGET). It can be as simple as two AA or AAA batteries placed in serial (2 x 1.5V).

Last update $Date: 2008/01/05 23:21:01 $ Introduction If you are looking for a simple but powerful programmer you are right, it's here. PonyProg is a serial device programmer software with a user friendly GUI framework available for Windows95/98/ME/NT/2000/XP and Intel Linux.

Its purpose is reading and writing every serial device. At the moment it supports I²C Bus, Microwire, SPI eeprom, the Atmel and Microchip micro. SI-Prog is the programmer hardware interface for PonyProg. With PonyProg and SI-Prog you can program Wafercard for SAT, eeprom within GSM, TV or CAR-RADIO.

Furthermore it can be used as a low cost starter kit for PIC and AVR. Kaneki ken kagune. Support PonyProg PonyProg works also with other simple hardware interfaces like (STK200/300),, and DT-006 AVR (by Dontronics).